Krohne OPTISENS PAC 050 EN Instrukcja Użytkownika Pobierz pdf (Strona 13)

Manual OPTISENS PAC 050

13 OPTISENS PAC 050

3.1.2 Adjustment of numerical parameters

Numerical parameters can only be altered when a double arrow is visible behind the number. This double

arrow appears when you address the parameter with key.

Adjust the parameter with keys  and . A short pressure on the key changes the last decimal by 1. If you

keep the key pressed, the value will continue changing until the pressure is released.

Store the changes with key „Enter“. The double triangle disappears.

Enter password

 058

1) Address the parameter with key .

Enter password

058 

2) A double arrow appears behind the number indicating that the number

can be changed now with keys  and .

Enter password

 062

3) Store the new value with key „Enter“. The double arrow disappears -

the new value is stored.

3.2 Menu Overview

6.98 pH 25.0°C

F S1 F S2 Auto

Display of the measured values (example)



Press key  to enter the main menu.

Main menu

Calibrate

Calibration function (only for pH measurements)

Temp. comp. Temperature compensation (only for pH measurements)

Enter password Password function

Set points Controller settings - set points, P ranges, I functions

Limit values

Alarm function

Basic settings



Cal. Pt 100

Service

Buffers used

Contr. Settings

Turn-on delay

Analog outputs

Language

Bus address

pH/ORP

All parameters which are set just once

at the beginning can be found in the

menu “basic settings“

3.2.1 Main menu and basic settings

The parameters are sorted into two menus: In the main menu you will find all functions which are used

regularly. The menu basic settings contain all parameters which are set just once during start-up.

On the following pages you will find information on how to adjust parameters and which parameters you

need for which application.

The information follows the following scheme:

1) General adjustments: password and language

2) Adjustments for measurement: calibration and temperature compensation for pH or selection of ORP

measurement

3) Adjustments of the controller: selection of the controller version and corresponding parameters

4) Adjustments to read out data: analog, digitally and/or as alarm

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 29 30

Komentarze do niniejszej Instrukcji

Brak uwag

Krohne OPTISENS PAC 050 EN Instrukcja Użytkownika Strona 13

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Ekwipunek Krohne OPTISENS PAC 050 EN